Change The Account-Log Mode - Oce 31x5e Maintenance Manual

Change the Account-log mode

Introduction
The account-log feature traces and records the job information. The
account-log feature is job-based and does not require any access control. When
a job is ready, the information about the job is sent from the machine memory
to the DAC. The information is stored and can be downloaded when you run
the Océ System Configuration.
The account-log system has two modes for managing the job information
transfer if the connection with the DAC has been lost. You can change the
default setting to protect the job processing of the machine.
Print the System log file to refer to information about any errors that have
occurred (see 'Print the DAC reports' on page 78).
To change the account-log mode, proceed as follows:
Account-log
mode
'Hold jobs'
'Ignore error'
If the connection with the DAC is restored, the machine automatically sets the
mode to 'Hold jobs' .
The mode 'Hold jobs' is also selected when the machine is switched off and on
again.
126 Océ 31x5E Configuration and Maintenance Manual
Result
The default setting. If the connection with the DAC is
lost, recording of the job information continues until 25
jobs are completed. Any subsequent jobs are prevented
and a message is displayed. To enable new jobs, change
the mode to 'Ignore error'
If the connection with the DAC is lost, recording of the
job information continues until 25 jobs are completed.
Any subsequent jobs result in replacing the earliest of the
25 stored jobs with the new job information.