Automatically Canceling The Mode Screen (Automatic System Reset); Automatically Conserving Energy (Low Power Mode) - Konica Minolta bizhub c450 Copy Operations

2

Automatically Canceling the Mode Screen (Automatic System Reset)

If no operation is performed for a specified length of time, the screen is au-
tomatically changed to that for the mode given priority.
This is the automatic system reset operation.
As the factory default, the Copy mode screen is displayed after 1 minute.
!
Detail
The mode screen that is displayed when the automatic system reset op-
eration is performed can be changed from the Utility mode. For details,
refer to "System Setting" on page 12-26.

Automatically Conserving Energy (Low Power Mode)

If no operation is performed for a specified length of time, the touch panel
goes off and the machine automatically enters a mode where it conserves
energy.
This is the Low Power mode.
The machine can receive jobs even while it is in Low Power mode.
As the factory default, the machine enters Low Power mode after 15 minutes.
To recover from Low Power mode
1
Press the [Power Save] key.
2
The machine can receive jobs while it is warming up.
– The touch panel comes on again and, after the machine has fin-
ished warming up, it is ready to begin printing (within 30 seconds at
normal room temperature (73.4 °F)).
Note
As the factory default, pressing the [Power Save] key causes the machine
to enter Low Power mode. Settings in the Administrator mode can be
changed to put the machine in Sleep mode instead. For details, refer to
"System Setting" on page 12-26.
The Low Power mode can also be canceled by pressing any key in the
control panel or by touching the touch panel.
2-32
Before Making Copies
C450