Konica Minolta bizhub c450 Copy Operations page 413

8
3
Specify the area to be erased.
– To cancel changes to the settings, touch [Cancel].
– To cancel the "Erase" function, touch [OFF].
What happens when [Frame] is selected?
?
% The same width is erased on all four sides of the document. The
factory default setting is "Frame".
Can the settings be combined?
?
% "Frame" cannot be combined with the other settings ("Top", "Left",
"Right" or "Bottom").
4
Touch [↔] to switch between the integer and the fraction, and then
touch [–] and [+] to specify the width to be erased.
– To specify a different width to be erased depending on the position,
specify different settings for "Top", "Left", "Right", and "Bottom".
– When using the keypad to specify the settings, press the [C] (clear)
key, and then specify the setting.
– If a decimal value is displayed in the screen, press the [C] (clear)
key, and then use the keypad to type in the setting. For details on
switching between decimal and fraction values, refer to "System
Setting" on page 12-17.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
5
Touch [OK].
6
If necessary, specify any other copy settings.
7
Using the keypad, type in the desired number of copies.
8
Press the [Start] key.
8-62
Application Functions
C450