Konica Minolta bizhub c450 Copy Operations page 338

Copy Paper/Original Documents
3
Touch [Custom Size].
4
Specify the X and Y sides of the paper, and then touch [Store].
– Make sure that [X] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side X. (5-1/2 in. to 18 in.)
– Make sure that [Y] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side Y. (3-9/16 in. to 12-1/4 in.)
– Check the illustration in the screen for the sides that are considered
X and Y.
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, "System Setting" on page 12-17.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
C450
7
7-17