Test And Adjustments - DCS RGT-305 Installation Manual

TEST AND ADJUSTMENTS

WARNING :
For warranty coverage, DCS requires that burner adjustments be made by a
qualified technician at the time of installation. Extreme care should be used
when adjustments are made after installation. IMPROPER OR LACK OF
ADJUSTMENT WILL VOID YOUR WARRANTY.
COOKTOP BURNERS
The cooktop burners are not adjustable. Proper operation is achieved when
the correct orifices for gas supply are installed at the factory, based on
model ordered.
When installing the burner port ring, be sure that the two locating pins in
the bottom side of the brass port ring are properly aligned with the locating
notch and center holes on the top side of the simmer ring. Incorrect
alignment will produce a potentially dangerous flame and poor burner
performance.
Note:
No air shutter adjustment is possible on the cooktop burners. Burner flames
should be blue and stable with no yellow-tipping (some yellow-tipping is normal
with LP gas), excessive noise, or lifting of flame from the burner (Fig. 17).
COOKTOP BURNER LIGHTING NOTE
The cooktop burners have an infinite number of heat settings and there are no fixed positions on the control
knobs between HI and LO. To turn the cooktop burner on, push in on the control knob and turn it counter-
clockwise to the "LITE" position. An audible clicking sound will be heard. When the gas has been ignited by the
electronic spark igniter, turn the knob to the desired setting (Fig. 18).
Note:
The igniter will continue to click until a flame is present. If the cooktop burner does not ignite, check the spark igniter by
listening for a clicking sound. If you do not hear the igniter click, turn off the burner. Check for a tripped circuit breaker,
blown fuse, or poor wire connection to the igniter.
WARNING:
When turning on any cooktop burner, be sure to stop at the "LITE" position before turning the burner to a flame
setting for cooking. If the burner is not lit and it is turned beyond the "LITE" position, to HI, MEDIUM, or LO, there
will be a burst of flame when the burner does light. This could cause burns or damage to the surrounding
countertop.
COOKTOP BURNER
1-1/2"
FIG. 17
OFF
LITE
HI
SIM
LO
FIG. 18
19