Setting The Ex60 In Standby - Cisco Telepresence System EX60 User Manual

Cisco Telepresence System EX60
Contents Introduction

Setting the EX60 in standby

Outside a call, you may have the unit enter standby mode by touching the Power
button on the main unit (the screen). The Standby dialog is displayed and the unit
enters standby immediately. This does not work when you are in a call.
Tap the touch
pad to wake up
the system from
standby.
Shutting down the EX60
Outside a call, press the Power button until the Shutdown progress bar is filled
completely.
Release the button and the unit will go in shutdown in just a few seconds.
D14779.04 User guide EX60, TC4.2, July 2011
All contents are Copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Connecting EX60 Using EX60
To start the system again,
press the Power button
until the LED illuminates
(green light).
22
The settings The settings
Reverting to factory default settings
To revert to the factory default settings, do as follows:
1. Disconnect the power cord.
2. Reconnect the power cord—a green light will illuminate shortly after.
3. Press the Power button as soon as the green light appears. Keep it depressed
for 15 seconds or so, until the green light starts flashing.
4. Release the button and press twice within 2 seconds. All settings will now revert
to factory default settings.
User guide
Web interface Contact us
www.cisco.com