Setting The Ex90 In Standby - Cisco EX90 User Manual

Cisco TelePresence System EX90
Contents Introduction

Setting the EX90 in standby

Outside a call, you may have the unit enter standby mode by touching the
Power button on the main unit (the screen). The Standby dialog is displayed
and the unit enters standby immediately. This does not work when you are in a
call.
Shutting down the EX90
Outside a call, press the Power button until the Shutdown progress bar is filled
completely.
Release the button and the unit will go in shutdown in just a few seconds.
D14724.09 User guide EX90, TC5.1, January 2013
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Connecting the EX90 Using the EX90
Tap as shown to
wake up the system
from standby.
To start the system again,
press the Power button
until the LED illuminates
(green light).
Scheduled meetings
Reverting to factory default settings
to revert to the factory default settings, do as follows:
1. Disconnect the power cord.
2. Reconnect the power cord—a green light will illuminate shortly after.
3. Press the Power button as soon as the green light appears. Keep it de-
pressed for 15 seconds or so, until the green light starts flashing.
Release the button and press twice within 2 seconds. All settings will now
4.
revert to factory default settings.
29
User guide
The settings The settings Contact us
www.cisco.com