Administrator Settings—Emc Resilience Mode - Cisco Telepresence System EX60 User Manual

Cisco Telepresence System EX60
Contents Introduction
Administrator Settings—EMC Resilience Mode
If the Touch controller is used in environments with
considerable amounts of electromagnetic noise present,
you may experience an appearance of false signals—as
if someone tapped the Touch controller when nobody
obviously did so.
To cope with this you may set the EMC Resilience
Mode to On. You must then press and hold for a little
while, rather than just tap, in order to make the system
aware of your tapping. This will avoid the appearance of
false signals.
As long as the system is used in environments without
consideable amounts of electromagnetic noise, the
setting should be set to Off (as shown).
D14779.04 User guide EX60, TC4.2, July 2011
All contents are Copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Connecting EX60 Using EX60
37
The settings The settings Web interface
User guide
Contact us
www.cisco.com