Setting The Ex90 In Standby - Cisco EX90 User Manual

Cisco TelePresence System EX90
Contents Introduction

Setting the EX90 in standby

Outside a call, you may have the unit enter standby mode by touching the Power
button on the main unit (the screen). The Standby dialog is displayed and the unit
enters standby immediately. This does not work when you are in a call.
Shutting down the EX90
Outside a call, press the Power button until the Shutdown progress bar is filled
completely.
Release the button and the unit will go in shutdown in just a few seconds.
D14724.03 User guide EX90, November 2010.
All contents are Copyright © 2010 Cisco Systems, Inc. All rights reserved.
Connecting the EX90 Using the EX90
Tap as shown to wake
up the system from
standby.
To start the system again,
press the Power button
until the LED illuminates
(green light).
23
The settings The settings
Reverting to factory default settings
To revert to the factory default settings, do as follows:
1. Disconnect the power cord.
2. Reconnect the power cord—a green light will illuminate shortly after.
3. Press the Power button as soon as the green light appears. Keep it de-
pressed for 15 seconds or so, until the green light starts flashing.
4. Release the button and press twice within 2 seconds. All settings will now
revert to factory default settings.
Changing background image on touch screen
The background image on the touch screen can be changed.
Do as follows:
1. Draw a circle with your finger anywhere on the screen where there are no
icons.
2. The below image will then appear on the touch screen screen. Tap one of the
small images to use it as background image.
User guide
Web interface Contact us
www.cisco.com