SmartNode 4660 & 4670 User Manual
4. For SN4671 models, connect the DSL cable (see section
Fiber port (SN4670 series only)"
5. Connect the power supply (see section
page 31)
Installing an interface cable on the SmartNode's FXS and FXO interface ports
Some models of the SmartNode include two to four FXS or FXO analog ports—or a combination of FXS and
FXO ports—located on the back of the unit (see
log devices via cables (see
Node with analog lines via cables terminated with RJ-11 connectors.
RJ-11, male
Ring (-) 3
Tip (+) 4
Connecting ISDN terminals and NT to the SmartNode's ISDN BRI ports
The SmartNode comes with two to eight (depending on the model) ISDN BRI ports located on the rear panel
Figure 2
(see
on page 17). All ports can be connected to the PSTN (ISDN NT) or terminals
For details on the BRI port pinout and ISDN cables, refer to
dix D, "Port Pin-outs"
Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables
The SmartNode has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any
of the ports can be connected to a host or hub/switch with a straight-through or cross-over wired cable.
1. Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
Note
The SmartNode Ethernet ports operate in Full Duplex mode only. Do not
connect to Half Duplex ports. For best results, use auto-negotiation. Auto
negotiation is mandatory when using 1000BaseT (Gigabit) Ethernet.
2. Connect port ETH 0/1 to your LAN.
For details on the Ethernet port pinout and cables, refer to
D, "Port Pin-outs"
on page 53.
Installing the SmartNode
on page 30)
"Verify that the green Power LED is lit (see Figure 7)."
Figure
6) terminated with RJ-11 connectors. The FXO interface connects the Smart-
Phone
Figure 6. Connecting the FXS/FXO interface
on page 53.
"Connecting the SmartNode's DSL, EFM or
Figure 2
on page 17). The FXS interfaces are connected to ana-
!
P o
w e
r
1 2
V ,
2 A
C o
n s
o le
E T
H
0 /3
E T
H
0 /2
E T
H
0 /1
E T
H
0 /0
0 /3
SN4661
(FXS/FXO ports)
Appendix C, "Cabling"
Appendix C, "Cabling"
3 • SmartNode Installation
0 /2
F X
S
0 /1
0 /0
B R
3
B R
2
B R
1
B R
0
RJ-11, male
3 Ring (-)
4 Tip (+)
on page 50 and
on page 50 and
on
Appen-
Appendix
29