SmartNode 4660 & 4670 User Manual
Compliance
EMC Compliance
•
FCC Part 15, Class B
•
EN55022, Class B
•
EN55024
Low Voltage Directive (Safety) Compliance
•
UL60950-1/CSA C22.2 No. 60950-1
•
IEC/EN60950-1 2nd Edition
•
AS/NZS60950-1
Radio and TV Interference
The SmartNode router generates and uses radio frequency energy, and if not installed and used properly-that is,
in strict accordance with the manufacturer's instructions-may cause interference to radio and television recep-
tion. The SmartNode router have been tested and found to comply with the limits for a Class B computing
device in accordance with specifications in Subpart B of Part 15 of FCC rules, which are designed to provide
reasonable protection from such interference in a commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the SmartNode router does cause interference to radio
or television reception, which can be determined by disconnecting the unit, the user is encouraged to try to
correct the interference by one or more of the following measures: moving the computing equipment away
from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different
AC outlet (such that the computing equipment and receiver are on different branches).
CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele-
vant provisions of Directive 1999/5/EC and Directive 2011/65/EC relating to RoHS compliance. The Decla-
ration of Conformity may be obtained from Patton Electronics, Inc at www.patton.com/certifications.
The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the
above directive is indicated by CE mark on the device.
Authorized European Representative
D R M Green
European Compliance Services Limited.
Greyfriars Court
Paradise Square
Oxford, OX1 1BE, UK
Compliance
A • Compliance Information
44