Table of Contents
Advertisement
SmartNode 4660 & 4670 User Manual
CodesSmartNode 4660 and 4670 Series Rear Panels
SmartNode 4660 Rear Panel
The SmartNode 4660 rear panel ports are described in
Figure 2. SmartNode 4660 rear panel (Model SN4661/4BIS4JS12V/EUI shown)
Port
ETH 0/0-0/3
BRI 0/0-0/7
FXS 0/0-0/7
(Analog voice port)
FXO 0/0-0/3
(Analog voice port)
Console
12V DC, 1.0A
CodesSmartNode 4660 and 4670 Series Rear Panels
Table 4. SN4660 rear panel ports
Switched Auto-MDX Fast-Ethernet port, RJ-45 (see
Internet Telephony Service Provider (ITSP) [via an xDSL or cable modem] or a remote
IP-PBX [via a private corporate network].
ISDN BRI TE/NT port, RJ-45 S0 (S/T) interface (see
with an ISDN device over an S/T bus, e.g. a PBX or an NT. The interface may be
used as fallback if connected to an NT. The port can be switched between TE and
NT mode. The interface is internally terminated with 100 ohm. Point-to-point or
point-to-multipoint configurable. If the port is in NT mode, a phantom power sup-
ply can be switched on to supply connected phones with power.
FXS RJ-11 (6 position, 4 wire) ports connect the SmartNode with an analog termi-
nal (a telephone, for example) FXO port. EuroPOTS support (ETSI EG201 188).
FXS on-hook voltage is 48V for each FXS port.
FXO RJ-11 (6 position, 4 wire) ports connect the SmartNode with an analog line
(FXS port). EuroPOTS support (ETSI EG201 188).
Used for service and maintenance, the Console port (see
45 connector, connects the SmartNode to a serial terminal such as a PC or ASCII
terminal (also called a dumb terminal).
The SmartNode has a 12V DC 1A power input (see
Table
4.
Description
Figure
1 • General Information
2), connect the unit to an
Figure
2), connects the unit to
Figure
2), an RS-232 RJ-
Figure
2).
17
Advertisement
Table of Contents
