SmartNode 4660 & 4670 User Manual
Port
Reset
LED
Pwr
Run
ETH 0/0 -0/3
Green LED
ETH 0/0 -0/3
Orange LED
BRI 0/0 - 0/7
Act LED
BRI 0/0 - 0/7
Link LED
CodesSmartNode 4660 and 4670 Series Rear Panels
Table 4. SN4660 rear panel ports (Continued)
The reset button (see
Figure
•
Restart the unit with the current startup configuration—Press (for less than 1
second) and release the Reset button to restart the unit with the current star-
tup configuration.
•
Restart the unit with factory default configuration—Press the Reset button for
5 seconds until the Power LED starts blinking to restart the unit with factory
default configuration.
Restart the unit in bootloader mode (to be used only by trained SmartNode
•
4660 technicians)—Starting with the unit powered off, press and hold the
Reset button as you apply power to the unit. Release the Reset button when
the Power LED starts blinking so the unit will enter bootloader mode.
Table 5. SmartNode SN4660 LED Definitions
Is on after 10sec when power is applied to the unit. Flashes once per
second during boot (startup).
When lit, the unit is in normal operation.
Flashes when data is received or transmitted at the corresponding
Ethernet port.
On when the Ethernet connection on the corresponding port has a link
indication.
On when Layer1 and Layer2 are active.
Off indicates no active calls. Blinking when one or two B-channels are
connected.
Description
2) has three functions:
Description
1 • General Information
18