Table of Contents
Advertisement
SmartNode 5570 User Manual
SmartNode 5570 Rear Panel
The SmartNode 5570 is a compact Enterprise Session Border Router that supports 30 VoIP or Fax calls, by
using either G.711, G.722, T.38 or any other codec as indicated under Voice Processing in Appendix B,
ifications"
on page 38. The SmartNode 5570 rear panel ports are described in
Ports descriptions
The SmartNode 5570 Series rear panel ports are described in
Port
ETH 0/0 & ETH 0/1 Auto-MDX Fast-/Gigabit-Ethernet port, RJ45 (see
USB 2.0
PRI 0/0 - PRI 0/1
SmartNode 5570 Overview
Figure 2. SN5570 Rear Panel
Table 2. Rear panel ports
unit to an Ethernet WAN device (for example, a cable modem, DSL
modem, or fiber modem).
USB 2.0 host port (see
Modem.
A list of supported USB Models can be found in the release notes and in
the Trinity Release 3.5.x- Command Line Reference Guide
RJ-45 connector providing E1 or T1 PRI interface, meeting
all requirements of ITU-T recommendations for G.703. Use a shielded E1
or T1 interface cable for 120 Ohm balanced connections to connect the
SmartNode with an NT or TE.
Note
Port 0/1 uses a different pin-out than 0/0. Port 0/1 is
intended to be connected to a PBX and port 0/0 to the
PSTN by using a straight cable for both ports. Different
usage may require a PRI cross-over cable.
Note
Appendix C on page 42
Refer to
Appendix D on page 47
table
2.
Description
figure
2) to connect a USB 3G/4G Cellular
for cabling and
for pin-outs
1 • General Information
table 2
on page 16.
figure
2), connects the
"Spec-
16
Advertisement
Table of Contents
