Installation Of Indoor Unit; Installation Of Remote Controller - Toshiba MMU-AP0091H Installation Manual

Installation of indoor unit

• Attach the nut (M10 or W3/8: Procured locally) and the attached
washer (Ø34mm) to the hanging bolt.
• Put washers at up and down of T-groove of the hanging bracket of
the indoor unit to hang the indoor unit.
• Using a level vial, check that four sides are horizontal.
(Horizontal degree: Within 5mm)
• Cut off the attached installation gauge from the installation pattern.
• Using the installation gauge, check and adjust clearance between the
indoor unit and the ceiling opening hole (1) (10 to 35mm common to
four sides) and hanging-down height (2) (12 mm: 4 corners).
(Using direction is printed on the installation gauge.)
Level vial (Horizontal: within 5mm)
Hanging bolt
Indoor unit
Hanging
metal
10 to 35
mm (2)
Installation
gauge
REQUIREMENT
Before installation of the indoor unit, be sure to
remove the cushion for transportation between
the fan and the bell mouth. Running the unit
without removing the cushion may damage the
fan motor.
Be sure to remove the cushion for transportation
between the fan and the bell mouth.
Installation of ceiling panel
(Sold separately)
Install the ceiling panel after piping/wiring work has
finished.
Install the ceiling panel according to attached
Installation Manual.
Check the installation dimensions of the indoor unit
and the ceiling opening are correct, and then install it.
+5
0
12 to 17
mm (1)
Indoor unit
Ceiling
board
Ceiling board
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Nut
(W3/8 or M10)
(1) Required those other than M10 flat
(2) To prevent falling-off of bolt (safety), be
+5
1) 12
mm
–0
Installation
gauge 2) 10 to
35mm
REQUIREMENT
Connect closely the connecting parts between the
ceiling panel and the ceiling surface or between
the ceiling panel and the indoor unit.
If they are incompletely connected, air leaks
resulted in dewing or water leakage.
First, remove the adjust corner caps (4 corners)
from the ceiling panel and then install the ceiling
panel to the indoor unit.

Installation of remote controller

(Sold separately)
For installation of the wired remote controller, follow
the Installation Manual attached with the remote
controller.
For installation of the wireless remote controller,
follow to the Installation Manual attached to the
remote controller.
• Do not put the remote controller on the place where
is exposed to direct sunlight or near a stove, etc.
• Operate the remote controller, check the indoor unit
surely receives the signal, and then install the
remote controller. (Wireless type)
• Install the remote controller 1m apart from the
devices such as TV or stereo. (Image may be
disturbed or noise may be output.) (Wireless type)
49
(1)
M10 flat washer
(Accessory)
(2)
M10 flat washer
(Accessory)
washer at site.
sure to set it just under the hanging
bracket as shown in the figure.