Toshiba MMU-AP0091H Installation Manual page 112

[Under Ceiling Type]
<Up/Down air direction adjustment>
Auto louver :
• When pushing LOUVER operation switch on the remote controller,
the discharge louver operates automatically. This increases the
cooling/heating effect.
• The louver operation switch can be handled only while the operation
lamp (Green) goes on.
• Stop the louver operation during defrost operation.
J In cooling operation
In cooling operation, use the discharge louver with horizontal set
point so that cool air diffuses the whole room.
J In heating operation
In heating operation, use the discharge louver with downward set
point so that the hot air is spread at the foot.
<Left/Right air direction adjustment>
When you change the blowout direction to left/right, direct the vertical
grille inside of the discharge louver to desired direction.
[High Wall Type]
The horizontal louver can operate automatically in order to increase
the cooling/heating effect.
<Up/Down air direction adjustment>
Auto louver :
• When pushing LOUVER operation switch on the remote controller,
the discharge louver operates automatically.
• The louver operation switch can be handled only while the
operation lamp (Green) goes on.
• Stop the louver operation during defrost operation.
J In cooling operation
In cooling operation, use the discharge louver with horizontal set
point so that cool air diffuses the whole room.
J In heating operation
In heating operation, use the discharge louver with downward set
point so that the hot air is spread at the foot.
• If cooling operation is performed with the louver blowing air down-wards, the surface of the cabinet or
discharge louver is wet with dew, and dewdrop may fall down.
• When heating operation is performed with horizontal set point, unevenness of the room temperature may
become large.
• Do not handle the discharge louver directly with hands. Select direction of the discharge louver by the
LOUVER operation switch on the remote controller. The discharge louver does not stop immediately even
if the switch has been pushed. Push the switch adjusting the stop position.
REQUIREMENT
112