Figure 206 Device Mode (Bridge Mode); Table 150 Device Mode (Bridge Mode) - ZyXEL Communications ZyWall 70 User Manual

ZyWALL 70 User's Guide
Table 149 Device Mode (Router Mode) (continued)
LABEL
Subnet Mask
Gateway IP
Address
Apply
Reset
When the ZyWALL is in bridge mode, the screen appears as shown next

Figure 206 Device Mode (Bridge Mode)

The following table describes the labels in this screen.

Table 150 Device Mode (Bridge Mode)

LABEL
Current Device
Mode
Device Mode
Device Mode Setup
Router
LAN Interface IP
Address
LAN Interface
Subnet Mask
406
DESCRIPTION
Enter the IP subnet mask of the ZyWALL.
Enter the gateway IP address.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
This displays whether the ZyWALL is functioning as a router or a bridge.
Select this radio button and click Apply to set the ZyWALL to router mode.
Enter the IP address of your ZyWALL' s LAN port in dotted decimal notation.
192.168.1.1 is the factory default.
Enter the IP subnet mask of the ZyWALL's LAN port.
Chapter 25 Maintenance