Pptp Encapsulation; Table 181 Fields In Menu 11.1 (Pppoe Encapsulation Specific) - ZyXEL Communications ZyWall 70 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 70:

Table of Contents

Service Name

Telco Option

Idle Timeout

33.3.3 PPTP Encapsulation

If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen.

Appendix F on page 605

Chapter 33 Remote Node Setup

If you are using PPPoE encapsulation, then type the name of your PPPoE service

here. Only valid with PPPoE encapsulation.

This field sets the authentication protocol used for outgoing calls.

Options for this field are:

CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this

remote node.

CHAP - accept CHAP only.

PAP - accept PAP only.

The field sets a ceiling for outgoing call time for this remote node. The default for this

field is 0 meaning no budget control.

This field is the time period that the budget should be reset. For example, if we are

allowed to call this remote node for a maximum of 10 minutes every hour, then the

Allocated Budget is (10 minutes) and the Period(hr) is 1 (hour).

You can apply up to four schedule sets here. For more details please refer to

This field specifies if you want to make the connection to this remote node a nailed-up

connection. More details are given earlier in this section.

Type the length of idle time (when there is no traffic from the ZyWALL to the remote

node) in seconds that can elapse before the ZyWALL automatically disconnects the

PPPoE connection. This option only applies when the ZyWALL initiates the call.

for information on PPTP.

ZyWALL 70 User's Guide