Unpacking; Connecting The Pinpad Device To The Terminal - VeriFone TRANZ 460 Reference Manual

Unpacking

Connecting the PINpad Device to the Terminal

Carefully inspect the shipping carton and its content for shipping damage. If
the PINpad device was damaged during shipment, immediately file a claim
with the shipping company and notify VeriFone, Inc.
Warning: Do not use the PINpad unit if it has been damaged.
1. Remove the PINpad unit from the shipping carton.
2. Remove any protective plastic wrap and place the unit on a table or
counter top.
3. Remove the protective plastic wrap from the display panel on the top of
the PINpad.
4. Replace all the packing materials, close the lid and save the carton for
repacking or moving the PINpad device in the future.
Unplug the terminal power pack before connecting the PINpad 101 device.
The PINpad 101 device rear panel has a modular, 4-wire interface port for
power and communication connection to the terminal.
Warning: Turn off or unplug the terminal whenever you connect or disconnect
the PINpad. Be sure the terminal is not processing data when you cut power.
Memory corruption and data loss can result.
Figure B-3 illustrates the PINpad
101 unit connection to a TRANZ
460 terminal.
Plug the cable into the PINpad
device connector on the rear of the
terminal. Use the rubber grommet
(cable cover) to protect the cord.
See the lower illustrations for more
detail.
1. Connect the modular plug on the
PINpad cable to the modular jack
on the rear of the PINpad unit.
2. Connect the other end of the cable
to the PINpad unit port on the
side of the terminal.
3. Spread the grommet open and put
it on the cord with the narrow
end facing the PINpad device.
TRANZ 460 Terminal
Appendix B. PINpad 101 Device
Figure B-3. PINpad 101 Device Cable
Connections
B - 3