Installing The Amplifi Er Unit - Wilson Electronics SignalBoost DT Installation Manual

Installing the Amplifi er Unit
!
Warning: The amplifi er unit is designed for use in an
indoor, temperature­controlled environment (less than 100
degrees Fahrenheit). It is not intended for use in attics or
similar locations subject to temperatures in excess of that
range.
!
Warning: The on­board antenna must have a
separation distance from all persons that is at least 8 inches.
!
Warning: Connecting the amplifi er
directly to the cell phone with use of an
adapter will damage the cell phone.
9
Desk or Table Mount
1. Attach the on­board antenna by screwing it onto
the threaded connector on the amplifi er. Position
the antenna at a 45­degree angle by adjusting it
on its base (see Figure 14). Note: the on­board
antenna may be positioned vertically; however,
this will require greater separation from the cradle
antenna (see Page 5).
2. Place the amplifi er on a desk, table or similar
surface where you have routed the coax cable.
!
that its on­board antenna has a separation distance of at
least 8 inches from all persons.
Figure 14
3. Attach the cable to the connector on the amplifi er.
Wall Mount
1. Attach the on­board antenna by screwing it onto
the threaded connector on the amplifi er (see
Figure 14).
2. Position the triangular wall­mount bracket at the
desired spot on the wall, at least 5 feet up from
the fl oor and away from any other amplifi er or
antenna.
!
that its on­board antenna has a separation distance of at
Figure 15
least 8 inches from all persons.
3. Using the bracket as a template, mark the
locations for the screws using a pencil.
4. Drill the holes, using a 3/16­inch drill bit, and
insert the screw anchors. Note: if you are not
using the wall­mount hardware in Packet B
for the cradle antenna, you can use it for the
amplifi er. Otherwise, you will need to purchase
three screws, washers and anchors.
5. Align the triangular bracket with the screw
anchors (Figure 15) and attach it with screws and
Figure 16
washers. Tighten the screws with a Phillips­head
screwdriver.
6. Slide the amplifi er onto the bracket. Position
the antenna at a 45­degree angle for best
performance (see Figure 16).
7. Attach the cable to the connector on the amplifi er.
For Technical Support, call 866­294­1660 or 435­673­5021.
Warning: RF Safety: The amplifi er must be placed so
Warning: RF Safety: The amplifi er must be placed so