Wilson Electronics SignalBoost DT Installation Manual page 13

Can I use my own cable for my installation?
The low­loss RG6 cable included with your product has been specifi cally selected for the SignalBoost DT. Use
of another type or longer length of cable will likely degrade the system's performance.
Can I use different antennas than the ones supplied in the box?
Yes! While the SignalBoost DT is designed to give you reliable signal improvement with the included antennas,
Wilson offers a variety of optional antennas and accessories that enable you to customize your SignalBoost DT
to your specifi c needs. Visit www.wilsonelectronics.com for details.
There are frequently several people using cell phones in my offi ce at the same time – will the SignalBoost DT
improve the signal for all of them?
Absolutely! The SignalBoost DT is designed to support multiple users simultaneously (within the range of the
on­board antenna).
I have installed the system but I don't have the coverage I need – what can I do?
See the section below.
For Weak Areas with Insuffi cient Signal
In areas with particularly weak outside signals, additional coverage can be obtained by removing the on­board
antenna and replacing it with a high­gain inside panel antenna (Wilson part #301147). This antenna (which
includes cable) can double the inside coverage area. (See Figure 18.)
Figure 18
Cell
Site
I have questions about my installation – where can I get some help?
Wilson's Technical Support representatives are just a phone call or email away. Call 866­294­1660 or 435­
673­5021, or send an email to tech@wilsonelectronics.com.
For Technical Support, call 866­294­1660 or 435­673­5021.
Cradle
Antenna
Minimum 20 feet
Amplifi er
Optional panel antenna (with cable) for
improved coverage inside the building
(Wilson part # 301147)
Panel
Antenna
12