Step 2 - Setting Up The Nursery Unit; Step 3 - Testing And Getting To Know Your Monitor - Angelcare AC300 Owner's Manual

STEP 2 - SETTING UP THE NURSERY UNIT

Keep
1 2
at least
1 m
6
5
4 3 2
NURSERY UNIT:
B
A
G
C
D
E
Front Side
10
1) Remove the battery door and insert
2 AA Alkaline Batteries (not included).
2) Place the Nursery Unit at a minimum
of 1 m away from the crib.
1
A) Movement 'TIC'
ON/OFF button
B) POWER ON/OFF switch
C) Movement 'TIC'
Indicator (flashing)
D) Alarm Indicator
F
E) Low battery indicator
F) Movement sensitivity
adjustment dial
G) Sensor Pad socket
H) Battery Door (not shown)
H
Back Side

STEP 3 - TESTING AND GETTING TO kNOW YOUR MONITOR

Test monitor when moving Sensor Pad to a new location to ensure sensitivity
is adjusted correctly to the new padding or mattress.
3.1 - SENSOR PAD
TO TEST SENSOR PAD:
2
1
3
4
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib
while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
TO STOP THE ALARM
Place your hand OR
back on the
mattress.
1) Turn ON Power/'TIC' switch
2) Move your hand lightly on the mattress.
3) Remove your hand from the mattress.
After 15 seconds you will hear a 'TIC'
pre-alarm sound.
4) 5 seconds later the alarm will sound and
the red light (Alarm Indicator) will flash
continuously.
MOVEMENT ALARM
• If NO movement is detected after
15 seconds you will hear a single 'TIC'
pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still
NO movement detected, Nursery Unit
speakers will emit a loud warning sound.
Shut the Nursery
Unit OFF
11