Setting Up The Nursery Unit; Wall-Mounted - Angelcare AC320 Owner's Manual

IMPORTANT
• If your cot does not have a solid, stationary, completely flat, firm
surface including a spring or slat base, place a hardboard between
the cot base and the Sensor Pad, to ensure correct operation. The
hardboard support must measure at least 30 x 30 cm (12" x 12")
and 6 mm (1/4") thick. This hardboard support must be larger than
the Sensor Pad surface area
• The Sensor Pad functions with standard cot sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby's movements
even when the baby is at the edges of the cot

3- SETTING UP THE NURSERY UNIT

Sensor Pad

WALL-MOUNTED

1
TABLETOP
1
6
ANGE_Manuel_AC327_SE_Complet_m2.indd 6
Place the Nursery
Unit and Adaptor cord
at least 1 metre
from the cot
2
Wall-Mounted
1
Tabletop
2
4
3
2
2019-04-03 7:44 PM