Step 2 - Setting Up The Nursery Unit - Angelcare AC420 Owner's Manual

STEP 2 - SETTING UP THE NURSERY UNIT

1
3 ft. 3
2
(0.9 m)
NURSERY UNIT:
A
B D
C
E
Front Side
10
1) Remove the battery door and insert
4 AAA Alkaline Batteries (not included).
2) Place the Nursery Unit at a minimum
of 3 feet (0.9 m) away from the crib.
3) Connect the AC Adapter to the Nursery
Unit and into an electrical outlet.
NOTE:
The batteries maintain power
supply in case of power outage.
A) Channel selector ON/OFF
night light button
B) Power ON/OFF
F
C) Low Battery / Power
Indicator
D) In range ON/OFF
G
E) Microphone
F) Night Light
G) Ventilation
H) AC Adapter Outlet
H
I) Microphone Sensitivity Dial
I
J) Battery Door (not shown)
J
Back Side
STEP 3 - TURNING ON YOUR MONITOR
1 2
When the Parent Unit is turned ON
and the Nursery Unit is OFF
OR
If there is a lost connection
between the 2 units (refer to
troubleshooting):
The Out-of-Range icon will blink
on the screen and the Parent Unit
will beep.
CHANNEL SELECTION
1
2 3 4
1) Press the Parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit Power
ON/OFF button.
NOTE:
The screen of the Parent Unit will show the
channel of transmission (C1 to C8) and after
5 seconds the room temperature and
function icons.
TO SELECT THE CHANNEL:
1) Press the "CH" key to enter or exit
the Channel Selection mode. The "--"
symbol will appear along with the In
Range icon which will flash.
2) Press the channel selector on the
Nursery Unit until the Night Light halo
flashes.
3) Select the channel by gently pushing
the channel selector on the Nursery
Unit (you will see the channel changing
on the Parent Unit).
4) Once the channel is selected, press and
hold the Channel Selector button on
the Nursery Unit to confirm selection
(halo will stop flashing to confirm
selection).
NOTE :
Both units are always on the same channel.
If the transmission is not clear, or if you hear
interference sounds, you should change the
channel. If the interference persists, consult
the Troubleshooting section.
E
N
11