Bridge Mode - ZyXEL Communications VMG5313-B30A User Manual

Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL
Rate Limit
WAN Outgoing
Default Tag
DSCP
MTU
MTU Size
Bridging and
Routing in the
same WAN
Enable Con-
current WAN
Apply
Cancel

6.2.1.2 Bridge Mode

Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 20 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
Chapter 6 Broadband
DESCRIPTION
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Select Enable and enter a DSCP (DiffServ Code Point) value to have the VMG add it in the
packets sent by this WAN interface.
If you enable Select WAN Outgoing Default Tag, enter a DSCP (DiffServ Code Point)
value to have the VMG add it in the packets sent by this WAN interface.
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Use this feature to bridge a LAN port(s) with the WAN interface. Traffic to/from LAN ports
not in the bridge is routed from the WAN interface.
ADSL use same VPI/VCI in Bridge and Route modes.
VDSL use same VLAN in Bridge and Route modes.
Enable this if you want to use the same VPI/VCI settings in different WAN interfaces. Select
this and then choose the ports to bridge with the WAN interface. \
• ADSL concurrent WAN uses the same VCI/PVI in both routing and bridge modes.
• VDSL concurrent WAN uses same VLAN in both routing and bridge mode.
Click Apply to save your changes back to the VMG.
Click Cancel to exit this screen without saving.
VMG5313-B10A/-B30A Series User's Guide
90