ZyXEL Communications VMG5313-B30A User Manual page 87

Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION
Service Select UBR Without PCR or UBR With PCR for applications that are non-time sensitive,
Category such as e-mail.
Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice or data
traffic.
Select Non Realtime VBR (non real-time Variable Bit Rate) for connections that do not
require closely controlled delay and delay variation.
Select Realtime VBR (real-time Variable Bit Rate) for applications with bursty connections
that require closely controlled delay and delay variation.
PPP Information (This is available only when you select PPPoE or PPPoA in the Mode field.)
PPP User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components exactly
as given.
PPP Password Enter the password associated with the user name above. Select password unmask to
show your entered password in plain text.
PPP Trigger Select when to have the VMG establish the PPP connection.
Type
Auto Connect - select this to not let the connection time out.
Connect on Demand - select this to automatically bring up the connection when the
Device receives packets destined for the Internet.Manual - select this if you want to
manually trigger the connection up.
Idle Timeout This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
This field is not configurable if you select Auto Connect in the PPP Trigger Type field.
PPPoE This field is available when you select PPPoE encapsulation.
Passthrough
In addition to the VMG's built-in PPPoE client, you can enable PPPoE pass through to allow up
to ten hosts on the LAN to use PPPoE client software on their computers to connect to the
ISP via the VMG. Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
PPPoE Service Enter the name of your PPPoE service here.
Name
PPPoE This field is available when you select PPPoE encapsulation.
Passthrough
In addition to the VMG's built-in PPPoE client, you can enable PPPoE pass through to allow up
to ten hosts on the LAN to use PPPoE client software on their computers to connect to the
ISP via the VMG. Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
IP Address (This is available only when you select IPv4 Only or IPv6/IPv4 DualStack in the IPv6/IPv4
Mode field.)
Obtain an IP A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed;
Address the ISP assigns you a different one each time you connect to the Internet. Select this if you
Automatically have a dynamic IP address.
DHCP This field displays when editing an existing WAN interface. Type the class vender ID you
option 60/
want the VMG to add in the DHCP Discovery packets that go to the DHCP server.
Vendor ID
Chapter 6 Broadband
VMG5313-B10A/-B30A Series User's Guide
87