ZyXEL Communications VMG5313-B30A User Manual page 89

Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION
IPv4 Mask Enter the subnet mask number (1~32) for the IPv4 network.
Length
6RD Border When you set the 6RD Type to Static, specify the relay server's IPv4 address in this field.
Relay Server IP
6RD IPv6 Prefix Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP's border relay router and connecting
to the native IPv6 Internet.
IPv6 Address (This is available only when you select IPv6/IPv4 DualStack or IPv6 Only in the IPv6/IPv4
Mode field.)
IPv6 Address Select Automatic if you want to have the VMG use the IPv6 prefix from the connected
router's Router Advertisement (RA) to generate an IPv6 address.
• Select Get IPv6 Address From DHCPv6 Server(IA_NA) if you want to obtain an IPv6
address from a DHCPv6 server. The IP address assigned by a DHCPv6 server has priority
over the IP address automatically generated by the VMG using the IPv6 prefix from an
RA. This option is available only when you choose to get your IPv6 address
automatically.
• Select Prefix Delegation(IA_PD) to use DHCP PD (Prefix Delegation) which enables
the Device to pass the IPv6 prefix information to its LAN hosts. The hosts can then use
the prefix to generate their IPv6 addresses.
Select Static if you have a fixed IPv6 address assigned by your ISP.
Select None to not assign any IPv6 address to this WAN connection.
Prefix Enter the address prefix length to specify how many most significant bits in an IPv6 address
Length
compose the network address.
Next Hop Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your VMG's interface(s). The gateway helps forward packets to their
destinations.
IPv6 Routing Feature (This is available only when you select IPv6/IPv4 DualStack or IPv6 Only in the
IPv6/IPv4 Mode field. You can enable IPv6 routing features in the following section.)
MLD Proxy Select this checkbox to have the VMG act as an MLD proxy on this connection. This allows
Enable the VMG to get subscription information and maintain a joined member list for each
multicast group. It can reduce multicast traffic significantly.
Apply as Select this option to have the VMG use the WAN interface of this connection as the system
Default default gateway.
Gateway
IPv6 DNS Configure the IPv6 DNS server in the following section.
Server
IPv6 DNS Select Dynamic to have the VMG get the IPv6 DNS server addresses from the ISP
automatically.
Select Static to have the VMG use the IPv6 DNS server addresses you configure manually.
IPv6 DNS Enter the first IPv6 DNS server address assigned by the ISP.
Server 1
IPv6 DNS Enter the second IPv6 DNS server address assigned by the ISP.
Server 2
VLAN (These fields appear when the Type is set to ADSL/VDSL over PTM.)
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
802.1q Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
QoS
Chapter 6 Broadband
VMG5313-B10A/-B30A Series User's Guide
89