Bridge Mode - ZyXEL Communications VMG8324-B10A series User Manual

Chapter 5 Broadband
Table 7 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL
MTU
MTU Size
Apply
Cancel

5.2.1.2 Bridge Mode

Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 24 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode )
The following table describes the fields in this screen.
Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
LABEL
General
Active
Name
Type
Mode
VLAN
Active
54
DESCRIPTION
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Click Apply to save your changes back to the Device.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The Device uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
This section is available only when you select ADSL/VDSL over PTM in the Type field.
Select this to add the VLAN Tag (specified below) to the outgoing traffic through this
connection.
VMG8324-B10A / VMG8324-B30A Series User's Guide