Adjust Dryness Level.
can be made only while
using Auto Dry Cycles.
Auto Dry Cycles take the guesswork out of drying time
and enhance fabric care. The amount of time that is
displayed is the estimated time remaining in the cycle.
use a Timed Cycle
Select a Timed Cycle.
Press the TIME ADJUST (More Time or Less Time)
buttons until the desired drying time is displayed. Press
MORE TIME or LESS TIME once and the time will change
by 1-minute intervals. Press and hold MORE TIME or
LESS TIME and the time will change by 5-minute
NOTE: The Time Adjust feature can be used only with
Press TEMPERATURE until the desired temperature
NOTE: During a Timed Cycle, you can change the settings for
Time, Temperature, WRINKLE GUARD _ and Cycle Signal.
NOTE: The Temperature feature can be used only with
(OPTIONAL STEP) If desired, select OPTIONS. For more
details, see "Options."
(OPTIONAL STEP) If desired, press CYCLE SIGNAL. A signal
will sound to alert you when a cycle ends. For more details,
see "Cycle Signal."
Press START. Be sure the door is closed.
If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically
If you wish to end your drying cycle after pressing Start,
press STOP twice.
To stop or pause your dryer at any time
Open the door or press STOP once. Press STOP twice to cancel
To restart the dryer
Close the door. Press START until dryer starts.
NOTE: Drying will continue from where the cycle was interrupted
if you close the door and press Start within 5 minutes. If the cycle
is interrupted for more than 5 minutes, the dryer will shut off.
Select new cycle settings before restarting the dryer.
©q! g ssd
Select the correct cycle and dryness leve( or temperature for your
load. If an Auto Dry Cycle is running, the display shows the
estimated cycle time when your dryer is automatically
the dryness level of your load. If a Timed Cycle is running, the
display shows the exact number of minutes remaining in the
Cool Down tumbles the load without heat during the last few
minutes of all cycles. Cool Down makes the loads easier to
handle and reduces wrinkling. The length of the Cool Down
depends on the load size and dryness level.
Follow care label directions when they are available.
If desired, add a fabric softener sheet. Follow package
To reduce wrinkling, remove the load from the dryer as soon
as tumbling stops. This is especially important for permanent
press, knits and synthetic fabrics.
Avoid drying heavy work clothes together with lighter fabrics.
This could cause overdrying of lighter fabrics and lead to
increased shrinkage or wrinkling.
Dry most loads using the preset cycle settings.
Refer to the Auto or Timed Preset Cycle Settings charts (in
the "Cycles" section) for a guide to drying various loads.
and dryness level are preset when
you choose an Auto Dry Cycle. You can select a different
dryness level, depending
on your load, by pressing
Dryness Level and choosing More, Normal or Less.
NOTE: You cannot use the Time Adjust and you cannot
choose a Temperature with the Auto Dry Cycles.
If you wish to adjust the cycle length of a Timed Cycle,
press the Time Adjust (More Time or Less Time) arrows.
Adjust the temperature
of a Timed Cycle by pressing
Temperature until the desired temperature
NOTE: You cannot choose a dryness level with Timed