Dryer Use - Kenmore 110.6705 Use & Care Manual

DRYER USE
STATUS
_mp
C®lDown
v_/rin_l_ Guarg
CheeklintScr_n_
MODIFIERS
;gh
0 L_w
b _mal E×_ Low
Dryness TernDe_ature
OPTIONS
Drum Light
Wrinkle Guard 90
[ovd
So_
Dy¢le Signal Volume
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.
WARNING: To reduce the risk of fire, electric shock, or injury to To use an Auto Dry Cycle
persons, read the IMPORTANT SAFETY INSTRUCTIONS before •
operating this appliance.
This booklet covers several different models. Your dryer may not
have all of the cycles and features described. •
Follow these basic steps to start your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before each load. See "Cleaning the Lint
Screen."
2. Place laundry into dryer and shut door.
3. Press POWER.
4. Turn the cycle selector knob to the desired cycle. The preset
settings for Auto Dry Cycles or Timed Cycles will illuminate.
The estimated (Auto Dry Cycles) or actual (Timed Cycles) •
cycle time (in minutes) will show in the display.
NOTE: A default time is displayed when an Auto Dry Cycle is
selected. During the first few minutes of the drying process,
the cycle time may automatically vary from the default time
based on the size and fabric type of the load. Toward the end
of the drying process, the estimated time display will adjust
again, showing the final drying time.
To make changes during an Auto Dry Cycle:
Press POWER.
Select an Auto Dry Cycle.
Select DRYNESS LEVEL to adjust how dry you want the
load. As the cycle runs, the control senses the dryness of
the load and adjusts the time automatically for the
selected dryness level.
The default dryness setting is Normal when an Auto Dry
Cycle is selected. You can select a different dryness level,
depending on your load, by pressing DRYNESS LEVEL
and choosing More, Normal or Less. Selecting More,
Normal or Less automatically adjusts the dryness level at
which the dryer will shut off. Once a dryness level is set, it
cannot be changed without stopping the cycle.
Select the desired Options.
•
Press STOR
18