Powered Center-Mount Legrest Adjustment - Quickie QM-7 Series Service Manual

3. There are 5 sets of holes as seen on the
front bars (A), and 6 sets of holes as seen on
the centerpost (B) (figure 8.4.1) Bolts can go
through any of these holes to give adjustability
of up to 6 inches from top to bottom. To extend
the front arms further, simply loosen 5mm
size SHCS screws and move the bars further
forward, then retighten.
4. Once desired height is achieved, Reset
placement of bolts then tighten with 5mm Hex
key and 13mm wrench. Tighten to correct
torque specifications (figure 8.4.1)
Caution: Allow at least 2" of Ground Clearance when making adjustments to the legrest, and
footplate assembly.

Powered Center-Mount Legrest adjustment

1. To perform Legrest adjustments (figure 8.4.2)
Operation of the 4-way switch is detailed below.
NOTE: It is also possible to perform these operations with the thru Drive using the joystick.
2 Right Command (2) - Controls the raising and
lowering of the leg on the center mount.
3. Reverse Command (3) - Operates both raising
and lowering Center Mount, plus extension of
the legrest (figure 8.4.3)
PAGE 8.4
JANUARY 2012
Section 8
A
QM-7 SERIES SERVICE MANUAL
B
fig. 8.4.1
fig. 8.4.2
fig. 8.4.3
SUNRISE MEDICAL