Section 8 Adjustment Procedures - Quickie QM-7 Series Service Manual

Section 8
Adjustment procedures
Seat/Back Width adjustment
Note: The same procedure is used for the 18" - 22" wide seating system
ASAP II Seating 16" - 20" wide is shown.
The ASAP II seating system is fully adjustable
A
to allow changes from 16" to 20" or 18" – 22".
This requires a frame weldment and seat pan
plates adjust for seat growth. The picture shown
in (figure 8.1.1) has a seat width of 20" . This
detail shows how easy it is to change back to
16" wide.
fig. 8.1.1
To make seating width adjustments follow the
following steps:
1. Have 3mm – 4mm – and 5mm Hex keys
available for the adjustments.
2. Loosen (do not remove) all of the M5 Button
Head Cap bolts (A) (figure 8.1.1). with a 4mm
Hex key, or a T-handle Hex key so that the
plates can slide for adjustment.
3. Using a 5mm Hex key, remove the socket
head cap screws (figure 8.1.2) that attach the
left and right wings to the seat frame.
fig. 8.1.2
4. Remove the 5mm socket head bolts with a
Hex key that are used to hold the bottom of the
seat pan in place (figure 8.1.3) – totally remove
from its position so that seat pan plates can slide
for adjustment.
fig. 8.1.3
SUNRISE MEDICAL QM-7 SERIES SERVICE MANUAL JANUARY 2012
PAGE 8.1