Quickie QM-7 Series Service Manual page 70

5. Remove the nut, and bolt that secures the
rear towel bar using a 4mm Hex Key and a
13mm open end wrench or ratchet as shown in
(figure 8.2.1).
6. Loosen the Back bracket on the chair to allow
for changes to the seat width. (figure 8.2.2).
NOTE: It is recommended to use the back width to accommodate the user, for example – 16
with 16 wide – 18 with 18" wide. If, however there is a ½ " adjustment needed, the brackets in
(figure 8.2.2) show that a ½" change equals a 1" accomadation to the user .
7. Using a 5mm Hex Key and either a 13mm
open end wrench or ratchet., Remove the nuts
and bolts from the back bracket attached to the
back cane assembly
necessary.
PAGE 8.2
JANUARY 2012
(figure 8.2.3) and adjust as
QM-7 SERIES SERVICE MANUAL
Section 8
fig. 8.2.1
fig. 8.2.2
fig. 8.2.3
SUNRISE MEDICAL