Page 1
SECTION ENGLI SH QM-710/715HD/720 ® Quickie QM-710/715HD/720 BC, SC, MPC / BD, SD, MPD Supplier: This manual must be given to the user of O w n e r ’ s M a n u a l this wheelchair. User: Before using this wheelchair read this entire manual and save for future reference.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 I. INTRODUCTION SUNRISE LISTENS USER WARNING Thank you for choosing a Quickie wheelchair. We want to hear WARNING your questions or comments about this manual, the safety and Attention wheelchair users, do not operate this wheelchair with- reliability of your chair, and the service you receive from your out first reading the owner’s manual.
Q M-7 10 /715HD/7 20 II. TABLE OF CONTENTS I. INTRODUCTION................2 P. POWER RECLINE ..............13 II. TABLE OF CONTENTS ...............3 Q.POWER LEGREST ACCESSORY .........13 III. YOUR CHAIR AND ITS PARTS ..........4 R. LIFT POWER ACCESSORY ...........13 IV. NOTICE– READ BEFORE USE...........5 S.
Q M-7 10 /715HD/7 20 IV. NOTICE– READ BEFORE USE A. CHOOSE THE RIGHT CHAIR & SAFETY 2. VI — GENERAL WARNINGS Here you will find a safety checklist and a summary of risks OPTIONS you need to be aware of before you ride this chair. Sunrise provides a choice of many power wheelchair styles, sizes and 3.
3. The configuration tested and found to be immune to at least 20 V/m is: Quickie QM-710 power wheelchair with a right- hand mounted RNET remote joystick system, 18" seat width, 18"...
Make sure you heed all warnings and follow all instructions in each WARNING section of this manual. Warnings that apply to the user also apply Never use non-Quickie parts to replace Quickie provided parts or to you. make changes to your chair unless authorized by Sunrise. (Doing so 1.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 G. WHEN SEATED IN A PARKED J. STREET USE WHEELCHAIR WARNING WARNING This product is not intended for street use. Avoid streets whenev- 1. Always turn off all power to your chair when you are er possible.
Q M-7 10 /715HD/7 20 M. TRANSFERS WARNING WARNING IF YOU MUST REACH OR LEAN, DO SO AT YOUR OWN It is dangerous to transfer on your own. It requires good balance RISK. and agility. Be aware that there is a point during every transfer when the wheelchair seat is not below you.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 R. RAMPS, SLOPES & SIDEHILLS chair from going over the edge. 2. Slope must not be steeper than one inch in height for every WARNING one foot of slope length (approximately 10º). The center of balance of your chair changes when you are on a 3.
Q M-7 10 /715HD/7 20 VII. WARNINGS: COMPONENTS AND OPTIONS 3. The footrest should always be in the down position when WARNING operating the chair. 4. Never lift this chair by the footrests. Footrests detach and Note: If you use parts or make changes not authorized by Sunrise will not bear the weight of this chair.
The powered CG Tilt accessory for this chair has a maximum user trol operates. Please contact your dealer or the Quickie Technical Service Department if you do not receive this information. Failure weight capacity of up to 300 lbs (400 lbs for the QM-715HD).
Q M-7 10 /715HD/7 20 VII. P. POWER RECLINE WARNING WARNING 1. Use only Wheelchair Tie-down and Occupant Restraint Pinch Point Systems (WTORS) which meet the requirements of SAE Avoid putting hands or fingers near the power recline mechanism J2249 Recommended Practice– Wheelchair Tie-down and while in operation.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 VIII. SET-UP, ADJUSTMENT AND USE A. ADJUSTMENT NOTES D. BATTERY REMOVAL 1. Work Surface For Set-Up: Use a flat surface, such as a table, to assemble, adjust and check your To remove the batteries for transporting or servicing: chair.
Q M-7 10 /715HD/7 20 VIII. E. FOLDING BACKREST Quickie QM-710/715HD/720 wheelchairs are shipped with backrest in folded position. (optional) 1. Upright Positioning a. Lift backrest to upright position so that latch handles (A) lock into place. b. Backrest is ready for use.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 VIII. 3. Calf Pad Adjustment a. Remove the two securing bolts (K). b. Move calf pads to desired height. c. Re-install bolts (K) through desired holes. I. R-NET JOYSTICKS 12 13 joystick power...
Q M-7 10 /715HD/7 20 VIII. K. DUAL-POST HEIGHT-ADJUSTABLE ARMRESTS (Option) FIXED HEIGHT STANDARD The dual-post flip-back armrest can be used as either a flip-back armrest or a removable armrest. 1. Installing Armrest a. Insert front and rear posts into armrest receivers. b.
Seating dimensions should only be altered by a trained profes- 3rd Hole sional and may require new seat cushions. Please refer to the QM-710/715HD/720 Service 4th Hole Manual for more detailed instructions on how to customize the size of your seat.
The On-board Programmer or RNET PC Programmer lets you adjust the control settings of the QM-710. Listed below are a few of the many settings that can be adjust via the On- board Programmer or RNET PC Programmer. (See RNET OBP Owners Manual for full pro- grammable parameters.)
Q M- 7 1 0/7 1 5 HD/ 7 2 0 D. THERMAL ROLL-BACK Your chair has a thermal roll back circuit. This protects the controller from damage due to overheating. In extreme conditions (such as repetitive hill climbing) the circuit will decrease the power to your motors.
Q M-7 10 /715HD/7 20 F. R-NET LED JOYSTICK 26 27 On/Off Button The on/off button applies power to the control system electronics, which in turn supply power to the wheelchair’s motors. Do not use the on/off button to stop the wheelchair unless there is an emergency.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 G. R-NET COLOR LCD SCREEN This section covers those joystick modules that are fitted with a color LCD screen. The color LCD screen is split into three areas of information. The Top Bar, the Base Bar and the Main Screen Area.
Page 23
Q M-7 10 /715HD/7 20 Inhibit (Fig. 14) If the speed of the wheelchair is being limited; for example, by a tilted seat, then this orange symbol will be displayed. If the wheelchair is being inhibited from driving, then this red sym- bol will be flashing.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 H. BRAKE LEVER Disengage the brake lever when you need to manually push the chair. (For example, in an emergency, or if batteries fail). WARNING 1. Do not disengage brake lever unless power to the chair is off. 2.
Q M-7 10 /715HD/7 20 3. Caution — To Avoid Damage to the Battery: WARNING • Make sure you use the correct setting for sealed (gel) batter- ies (located on the off-board charger). Never touch the charger after it is connected to an electrical out- •...
Q M- 7 1 0/7 1 5 HD/ 7 2 0 XI. MAINTENANCE A. NOTES D. BATTERY MAINTENANCE 1. Proper maintenance will improve performance and extend WARNING the useful life of your chair. 1. To prevent an acid spill, always keep batteries upright (wet 2.
Inflate tire to proper pressure level (listed on tire sidewall). Trouble shooting I. FUSES Your Quickie QM-710/715HD/720 has two inline fuses. • In the unlikely event of a short circuit or other fault, all power to your chair will be shut off.
Q M- 7 1 0/7 1 5 HD/ 7 2 0 XII. SUNRISE LIMITED WARRANTY A. FOR FIVE (5) YEARS E. WHAT WE WILL DO Sunrise warrants the frame of this wheelchair against defects in Our sole liability is to repair or replace covered parts. This is the materials and workmanship for five years from date of first con- exclusive remedy for consequential damages.