Set Motion Detection Area - KGuard Security Aurora Series User Manual

Note:
• It is advised to avoid using wireless cameras with any of the motion recording equipment. The wireless
technology is sensitive to interference, and therefore common issues like static and image distortion might
trigger the motion detection unintentionally.
• It is recommended to set the sensitivity level at the moderate level so that the DVR only record the
particular scene when 'motion' is detected. If it is set at the highest level, the DVR may record continuously.
• Do not use PTZ system and motion detection function at the same time to avoid wrong 'motion'
interpretation.
Area: Select the area for motion detection alarm. See
Schedule: Motion detection is triggered only based on the start and end time described in the schedule . See
"Motion Schedule Setup" on page
Trigger: Configure the actions to be taken when motion is detected. See
Copy CH/To CH: Copy the current settings to all channels or one specific channel. Click the arrow to select an option
and then click Copy.
After all settings are complete, click Apply.

• Set Motion Detection Area

"Set Motion Detection Area" on page
44.
Aurora Series: Configuring DVR Settings
43.
"Motion Trigger Settings" on page
In Area, click Settings and specify the
area for motion detection alarm.
By default, the whole screen is marked
for motion detection (green block).
• To disable motion detection on
an area, click the grid cursor and
then drag the mouse to highlight
the scope to unmark the area.
• Right click to close the setup
screen.
Note:
To avoid getting false triggers, it is
recommended to set the motion
detection area at an appropriate
location such as door, window, etc.
44.
DVR User's Manual
43