Physical Characteristics; Power Requirements - Focusrite RedNet Installation Manual

PHYSICAL CHARACTERISTICS

RedNet 3's dimensions are shown in the diagram below:
247.5mm / 9.74"
RedNet 3 requires 2U of vertical rackspace and at least 350 mm of rack depth, to allow for cables.
RedNet 3 weighs 4.34 kg, and for installations in a fixed environment (e.g., a studio), the front panel
mounting screws will provide adequate support. If the units are to be used in a mobile situation
(e.g., flight-cased for touring, etc.), consideration should be given to using side support rails within
the rack.
RedNet 3 generates no significant heat, and is cooled by natural convection. We recommend that the
unit should not be used in locations where the ambient temperature is greater than 30°C (85º F).
Ventilation is via slots in the enclosure at both sides. Do not mount RedNet 3 immediately above any
other equipment which generates significant heat, for example, a power amplifier. Also, ensure that
when mounted in a rack, the side vents are not obstructed.

POWER REQUIREMENTS

RedNet 3 is mains-powered. It incorporates a 'Universal' power supply, which can operate on any AC
mains voltage from 100 V to 240 V. The AC connection is made via a standard 3-pin IEC connector on
the rear panel. A mating IEC cable is supplied with the unit, which should be terminated with a mains
plug of the correct type for your country.
The maximum rated AC power consumption of RedNet 3 is 30 VA.
Please note that there are no user-replaceable fuses in RedNet 3, or other user-replaceable
components of any type. Please refer all servicing issues to the Customer Support Team
(see "Customer Support and Unit Servicing" on page 55).
465.0mm / 18.30"
76.2mm / 3"
19