Connectors - Focusrite RedNet Installation Manual

First Use and Firmware Updates
Your RedNet 2 will require a firmware update when it is first installed and switched on. Firmware
updates are initiated and handled automatically by the RedNet Control application. It is important
that the firmware update procedure is not interrupted, either by switching off the RedNet 6 or the
computer on which RedNet Control is running or disconnecting either from the network.
From time to time Focusrite will release RedNet firmware updates with new versions of RedNet
Control. We recommend keeping all RedNet units up to date with the latest firmware version
supplied with each new version of RedNet Control.

CONNECTORS

8-channel analogue input and output connectors
Connector type: 25-pin female Dsub
Applies to: ANALOGUE INPUTS 1-8, ANALOGUE INPUTS 9-16
ANALOGUE OUTPUTS 1-8, ANALOGUE OUTPUTS 9-16
Standard: AES 59 (AKA Tascam wiring)
Input/Output
Pin
1-8
1 Ch 8 'hot' (+)
2 Ch 8 screen
3 Ch 7 cold (-)
4 Ch 6 'hot' (+)
5 Ch 6 screen
6 Ch 5 cold (-)
7 Ch 4 'hot' (+)
8 Ch 4 screen
9 Ch 3 cold (-)
10 Ch 2 'hot' (+)
11 Ch 2 screen
12 Ch 1 cold (-)
13 n/c
Input/Output
Pin
9-16
Ch 16 'hot' (+) 14
Ch 16 screen 15
Ch 15 cold (-) 16
Ch 14 'hot' (+) 17
Ch 14 screen 18
Ch 13 cold (-) 19
Ch 12 'hot' (+) 20
Ch 12 screen 21
Ch 11 cold (-) 22
Ch 10 'hot' (+) 23
Ch 10 screen 24
Ch 9 cold (-) 25
n/c
Input/Output Input/Output
1-8 9-16
Ch 8 'cold' (-) Ch 16 'cold' (-)
Ch 7 'hot' (+) Ch 15 'hot' (+)
Ch 7 screen Ch 15 screen
Ch 6 'cold' (-) Ch 14 'cold' (-)
Ch 5 'hot' (+) Ch 13 'hot' (+)
Ch 5 screen Ch 13 screen
Ch 4 'cold' (-) Ch 12 'cold' (-)
Ch 3 'hot' (+) Ch 11 'hot' (+)
Ch 3 screen Ch 11 screen
Ch 2 'cold' (-) Ch 10 'cold' (-)
Ch 1 'hot' (+) Ch 9 'hot' (+)
Ch 1 screen Ch 9 screen
13