Air Conditioner Removal - Kenmore 78122 Owner's Manual

_'[_"] FRONT INSTALLATION
• Hook upper tabs of front grille into slots on the
cabinet top.(FIG. 19)
• Push front grille towards the cabinet in order to
snap side tabs into the cabinet.(FIG. 19)
• Open the filter door.(FIG. 20)
• Install the TYPE A screw (_ through the front
grilte.(Fig. 20)
• Close filter door.(Fig. 21)
ii
Front Installation FIG. 19
IF AIR CONDITIONER IS BLOCKED BY STORM
WINDOW FRAME
Add wood to clear frame as shown in FIG. 22, or
remove storm window while air conditioner is
installed,
_Sash
Wood block 1l/2"min
in area of\
_aSm___j_
leveling I]"",J_ L
support _lLt_ " r_ T
] _ " I Board thicknessas
I _ required, along
Storm window frame entire stool.
or other obstruction Fasten with two
nails or screws.
FIG. 22
Front installation FIG. 20
AIR CONDITIONER REMOVAL
Turn the air conditioner off, disconnect the power
cord, remove the window looking bracket and the
screws installed through the top and bottom of the
side curtains. Save all parts for later reinstallation.
Close the side curtains. Keeping a firm grip on the
air conditioner, raise the sash, and carefully tilt the
air conditioner backward, draining any condensed
water. Lift the air conditioner from the window.
Remove the sash seal from between the windows.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner,be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
Front Installation
FIG. 21
-8-