Features; Using The Air Conditioner - Kenmore 35900 Owner's Manual

FEATURES

11 7 8
10
3
2
6
5
4
11. Cabinet
12. Horizontal Air Direction Control Tab
13. Cool Air Discharge
14. Inlet Grille
15. Air Filter
16. Front Grille
17. Control Knob
18. Upper Guide
19. Curtain
10. Power Switch
11. Fan Speed Switch
OPERATION
1
9
FIG. 12
- 9 -

USING THE AIR CONDITIONER

To reduce the risk of fire, electric
shock, or injury to persons, read the important
SAFETY instructions section before operating this
appliance.
To begin operating the air conditioner after
installation, follow these steps:
1. Plug in the air conditioner. (To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Turn Power Switch on.
3. Set the Control Knob control to the coolest setting.
4. Set the Fan Speed Switch control at the high level.
5. Adjust the air direction control tabs for comfortable
air flow.
6. Once the room has cooled, adjust the Control
Knob and Fan Speed Switch control to the setting
you find most comfortable.
NOTE : If the air conditioner is turned off, wait 3
minutes before restarting. This allows pressure
inside the compressor to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation.
If you move the Control Knob control to a warmer,
then immediately back to a cooler setting, the unit
will shut off. Wait 3 minutes before restarting.
Refer to the AIR CONDITIONER FEATURES
section for other settings.(See page 10)