Operating Notes; Rm Quick Reference - Lectrosonics SMDB/E01 Series Instruction Manual

Operating Notes

• The sensitivity to the
remote control varies with
the transmitter's audio
level setting and the
microphone used, but it is
always possible to make
it work with a sufficiently
loud remote signal at
close range.
• If the transmitter is con-
figured to respond to the
remote control, it will do
so even if the buttons are
locked.
• When the transmitter is
asleep, it can only be
awakened by the remote
control, or by removing
and reinserting the bat-
tery.
• When the transmitter is asleep, the PWR led
blinks green every few seconds.
• If a remote command is sent that would result in
the same display being shown again on the trans-
mitter (for example tuning to the channel already
displayed), a row of dashes is displayed briefly,
as a signal that the command was received, but it
didn't change anything.
• If you are having trouble getting the transmit-
ter to respond, make sure you aren't covering
the speaker w ith your thumb, and/or turn up the
speaker volume on the Loud page.
• If the RM/E is set to a different block number than
the transmitter and an attempt is made to set the
transmitter's frequency in MHz, the command
will still work. The transmitter is simply set to the
corresponding channel in the correct block, with a
matching hexadecimal number.
• The audio signal from the RM/E will change the
settings of all transmitters within range. Experi-
ment with this to prevent accidental changes to
another transmitter during a production.

RM Quick Reference

Power On/Off
Set audio level
Sleep or Wake
Lock or Unlock
Adjust RM/E volume
Set Frequency (hex)
Enable MHz display
Set channel (CH - MHz)
Rio Rancho, NM
AUDIO+FREQ
Aud page (via AUDIO)
SLEEP/unSLP page (via AUDIO)
Loc/unLoc page (via AUDIO)
Loud page (via AUDIO)
CH page (via FREQ)
b (block) page (via FREQ)
000.000 page (via FREQ)
Super-Minature Belt Pack Transmitters
The RM/E should be held close enough to the microphone to
change the settings on the intended transmitter, and not be
loud enough to affect other transmitters nearby.
Important: The remote control (RC) mode
must be enabled on your SM Series
transmitter for the RM/E to function with
it. For instructions, refer to page 7 of this
publication.
15