Introduction - Baxi TS Super Installation And Servicing Instructions

Boiler Thermostat
Green Power
ON Indicator
ON/OFF
Button
Green
High Setting
Indicator
HIGH/LOW
Button
Green
Illumination
ON Indicator
Illumination
Button
Controls & Bezel
Fig. 1
Boiler Thermostat
1.3 Important Information
This product uses fuel effect pieces containing Refractory Ceramic Fibres
(R.C.F.) which are man-made vitreous silicate fibres. Excessive exposure
to these materials may cause temporary irritation to eyes, skin and
respiratory tract. Care must be taken when handling these articles to
ensure the release of dust or fibres is kept to a minimum.
4
Knob
Controls Access Door
Knob
Controls Access Door
1.1
1. Your Baxi Bermuda Inset 3 Super is a central
heating boiler combined with a gas fire. The
firefront is of the Decorative Fuel Effect type and
incorporates an optional illumination effect for
use when the fire is off. The boiler will provide
heating for the rest of the house and also
domestic hot water if required. The boiler and fire
are independently controlled.
2. The boiler and fire unit is designed to be used
on Natural Gas only.
3. The fire is controlled by three switches
situated on the upper left hand side of the fire
surround (Fig. 1). The fire has three settings:
4. The boiler controls are located behind the
controls access door.
Bermuda Inset 3
5. The boiler may be controlled by an external
TS, BS,KS & SC Super
programmer or clock control (see separate
instructions with the clock controller used).
Manual control is available with the boiler
thermostat control.
NOTE: The fire or illumination effect will not
function in the event of a power failure.
1.2
The appliance is suitable only for installation in
GB and IE and should be installed in
accordance with the rules in force.
In GB, the installation must be carried out by a
CORGI Registered Installer. It must be carried out
in accordance with the relevant requirements of
the:
• Gas Safety (Installation & Use) Regulations.
• The appropriate Building Regulations either The
Building Regulations, The Building Regulations
(Scotland), Building Regulations (Northern
Ireland).
• The Water Fittings Regulations or Water Byelaws
in Scotland.
• The Current I.E.E. Wiring Regulations.
Bermuda Inset 3
FS, BB, CB & BC Super
Where no specific instructions are given, reference
should be made to the relevant British Standard
Code of Practice.
In IE, the installation must be carried out by a
competent Person and installed in accordance
with the current edition of I.S. 813 'Domestic Gas
Installations', the current Building Regulations and
reference should be made to the current ETCI
rules for electrical installation.
These Instructions must be read in conjunction
with those for the Boiler Section before
installing or using this appliance.
NOTE: All illustrations show the Inset 3 TS Super. The
procedure for Installation, Commissioning, Servicing
etc. is the same for all Bermuda Inset 3 Super models

1.0 Introduction

Description
OFF LOW
Installation
HIGH
.
1