Arranging The Coals - Baxi TS Super Installation And Servicing Instructions

Side Cheek
Location Stop
Fig. 25
Rear Coal Side
Support Ledges
Fig. 26
Rear Coal Spacer Lugs
Burner
Bracket Lip
Fig. 27
Fig. 28
Fig. 29
14
Combustion Box Base Front Lip

7.0 Arranging the Coals

7.1 Arranging the Coals
It is important that all the coals are used and
arranged as shown in order to achieve the
desired flame picture.
1. Remove the loose coals, side cheeks, rear and
front coals from their protective packaging and
place them on a newspaper or similar to prevent
soiling furnishings.
CAUTION: The coals are extremely fragile and
must be handled accordingly. Gloves should be
worn and any inhalation of the dust should be
avoided. Keep the coals away from children at
all times. Never use coals other than those
originally supplied or Genuine Baxi Spare
Parts. Never put additional coals on the fire.
Please read section 1.3 Important Information.
2. Place the right / left hand side cheeks against
the combustion box side walls (Fig. 25).
3. Locate the rear coal behind the combustion box
base front lip and angle it back against the side
cheek location stops (Figs. 25 & 26).
4. Locate the front coal onto the rear coal side
support ledges and behind the lip of the burner
bracket (Figs. 26 & 27).
5. Place 5 of the loose coals into the location
recesses of the front coal, (flat face downward).
The 3 centre coals should rest against the
corresponding rear coal spacer lugs. Orientation
of the coals should be as shown in order to
achieve the desired flame picture (Fig. 28).
6. Place the remaining 4 loose coals between the
front loose coals and the rear coal, (flat face
downward). Orientation of the coals should be as
shown in order to achieve the desired flame
picture (Fig. 29).