Baxi TS Super Installation And Servicing Instructions page 26

Glass Retaining Assembly
Amber Glass Pieces
Control Panel
Connector Socket
26
Fig. 81
Halogen Bulbs
Fig. 82
Fig. 83
Gas Valve Bracket
Fig. 85
10.7
IMPORTANT: Only replace the bulb/s with a 12V
20W halogen capsule bulb available at most DIY
outlets, specialist electrical stores or through
Baxi.
1. Remove the coals, placing them on a
newspaper or similar to prevent soiling
furnishings.
2. Lift out the glass retaining assembly (Fig. 81).
3. Remove the bulb by pulling out from the
ceramic bulb holder to disengage the pins
(Fig. 82).
4. Fit the replacement bulb in reverse order.
NOTE: Halogen bulbs should not be handled with
bare fingers. Always use a cloth to grip the bulb.
5. Replace the glass retaining assembly and
reassemble the coal bed.
10.8
1. Remove the coals, placing them on a
newspaper or similar to prevent soiling
furnishings.
2. Lift out the glass retaining assembly (Fig. 81).
3. Carefully remove the three amber glass pieces
(Fig. 83).
4. Fit the new glass and reassemble the coals.
10.9
Transformer Assembly The transformer assembly is situated at the rear of
the fire at the left hand side.
1. Loosen the two screws, securing the assembly
to the rear of the fire.
2. Slide the assembly upwards and disengage
from the fire back.
3. Disconnect the control panel connector socket
from the gas valve bracket (Fig. 85).
Fig. 84
4. Disconnect the two bulb connections to the
transformer.
5. Disconnect the two control box connections to
the transformer.
6. Reassemble in reverse order.
10.0 Changing Components
Bulbs
Glass
Transformer Assembly (Fig. 84)