Adding Voice Annotation To Saved Data - Fluke Ti32 User Manual

Ti32, TiR32
Users Manual
4. When ready to review the details of a specific image, press the softkey
labeled Select.
To delete a single Image from the SD memory card:
1. Perform the steps under viewing stored images to display the image.
2. Press the softkey labeled Select.
3. Press the softkey labeled Delete.
To delete all the images from the SD memory card:
1. Press the softkey labeled Select.
2. Press the softkey labeled Delete.
3. Press the softkey labeled All Images.
4. To exit Review mode, squeeze the trigger once to return to the live view.

Adding Voice Annotation to Saved Data

Voice annotation can only be added to an image prior to storing it. After
capturing an image, the Image Capture menu appears. To add a voice
annotation to the image:
1. Press the softkey labeled Audio.
2. Press the softkey labeled Record to start the recording.
3. Speak into the Imager's microphone opening. Up to 60 seconds of audio
can be recorded for each image.
4. When done recording, press the softkey labeled Review to listen to what
was recorded. When an audio recording has been created for an image, e
appears in the display while the image is displayed. To keep the audio
annotation, proceed to the next step. Otherwise, press the softkey labeled
Append or Replace to modify the recording before storing the image.
Once stored, the audio annotation can only be reviewed and not modified.
5. Press the softkey labeled Back to return to the Audio menu.
6. Press the softkey labeled Store to store the measured data and audio
annotation.
22