Charging The Battery; Two-Bay Charging Base - Fluke Ti32 User Manual

Ti32, TiR32
Users Manual
• User Manual (in various languages)
®
• SmartView
Software
• Warranty Registration Card
Fluke recommends the use of the supplied SD memory card with the
Imager. Fluke does not warrant the use or reliability of aftermarket
SD memory cards of different brands or capacities.
See Table 2 for a list of accessories that are available for the Imager.
Model
FLK-TI-LENS/WIDE1
FLK-TI-LENS/TELE1
FLK-TI-SBP3
FLK-TI-SBC3
TI-CAR CHARGER

Charging the Battery

Before using the Imager for the first time, charge the batteries in the included
two-bay charging base for at least two and one-half hours. The charging status
of each battery will be shown on the five-segment battery charge indicator on
each battery.
New batteries are not fully charged. Two to ten normal
charging/discharging cycles may be required before the battery
charges to its maximum capacity.
To charge the Imager's battery, select one of the options that follow:

Two-Bay Charging Base

1. Plug the ac power supply into an ac wall outlet and connect dc output
to charging base.
2. Insert one or two smart batteries into bays of charging base.
3. Charge batteries until charge indicators show "full".
4
Note
Table 2. Accessories
Description
Wide Angle Infrared Lens
Telephoto Infrared Lens
Smart Battery Pack
Charging Base/Power Supply with
Adapters
12 V Vehicle Charger Adapter
Note
PN
3441183
3441176
3440365
3440352
3039779