Before You Start; Battery; Two-Bay Battery Charger Base - Fluke TiS10 User Manual

TiS10, TiS20, TiS40, TiS45, TiS50, TiS55, TiS60, TiS65
Users Manual

Before You Start

Carefully unpack the items in the shipment box:
Item
Two-Bay Battery Charge Base
Lithium-ion Smart Battery
Hard Carrying Case
Soft Case
Micro SD Card and Adapter
AC Power Supply with Mains Adapters
Mini USB-to-USB Cable
Quick Reference Guide
Safety Information
Users Manual, SmartView
(on USB Drive)
Fluke recommends the removable memory card that is
supplied with the Imager or available from Fluke. Fluke
does not warrant the use or reliability of aftermarket
memory cards of different brands or capacities.
To request a printed manual, email Fluke at
TPubs@fluke.com. Specify the product name and
language preference in the subject line.
6
• • • • •
• • • •
• • • • •
• • •
• • • • •
• • • • •
• • • • •
• • • • •
 • • • • •
Software

Battery

Before you use the Imager for the first time, charge the
battery for a minimum of 2.5 hours. The battery status
shows on the four-segment charge indicator.
To prevent personal injury, do not put battery
cells and battery packs near heat or fire. Do
not put in sunlight.
•
x2
New batteries are not fully charged. Two to ten
charge/discharge cycles are necessary before the
battery charges to its maximum capacity.
To charge the battery, use one of the options that follow:

Two-Bay Battery Charger Base

1. Connect the ac power supply to the ac wall outlet and
connect the dc output to the charger base.
2. Put one or two smart batteries into bays of charger
base.
3. Charge batteries until charge indicators show "full."
4. Remove smart batteries and disconnect the power
supply when batteries are fully charged.
 Warning
Note