Table of Contents
Advertisement
Maintenance
The Imager does not require maintenance.
To prevent eye damage and personal injury, do not open the Product. The laser beam is
dangerous to eyes. Have the Product repaired only through an approved technical site.
Clean the Case
Clean the case with a damp cloth and a weak soap solution. Do not use abrasives, isopropyl alcohol, or solvents
to clean the case.
Lens Care
To prevent damage to the infrared lens:
•
Carefully clean the infrared lens. The lens has a delicate anti-reflective coating.
•
Do not clean the lens too vigorously because this can damage the anti-reflective coating.
To clean the lens:
1. Use a pressurized can of air or a dry nitrogen-ion gun, if available, to blow off the particulates from the lens
surface.
2. Soak a lint-free cloth in a commercial lens cleaning liquid that contains alcohol, ethyl alcohol, or isopropyl
alcohol.
3. Squeeze the cloth to remove excess liquid.
4. Wipe the lens surface in one circular motion and discard the cloth.
5. If needed, repeat with a new lint-free cloth.
Battery Care
To prevent personal injury and for safe operation of the Product:
•
Do not put battery cells and battery packs near heat or fire. Do not put in sunlight.
•
Do not disassemble or crush battery cells and battery packs.
•
Remove batteries to prevent battery leakage and damage to the Product if it is not used for an
extended period.
•
Connect the battery charger to the mains power outlet before the charger.
•
Use only Fluke approved power adapters to charge the battery.
•
Keep cells and battery packs clean and dry. Clean dirty connectors with a dry, clean cloth.
*W Warning
W Caution
W Warning
Professional Series Thermal Imagers
Maintenance
43
Advertisement
Table of Contents
