Lamp; About The Lamp; Lamp Replacement - Martin smartMAC User Manual

Lamp

WARNING! Installing a lamp that is not specified in this manual may create a safety hazard and
damage the fixture. Replace the lamp immediately if it is deformed or in any way defective.

About the lamp

The smartMAC is designed for use with a Philips MSD 150/2 discharge lamp and is supplied with this lamp
installed. The Philips CDM-SA/T 150W/942 lamp is also approved for use with the smartMAC. These lamps
have the following specifications:
Lamp
Philips MSD 150/2
Philips CDM SA/T 150
The Philips MSD 150/2 lamp has a color temperature of 8500 K, a color rendering index of approximately
70, and an average service life of 3000 hours at full intensity.
To reduce the risk of lamp failure or explosion, replace the lamp when it reaches the limit of its average
service life. Hours of lamp use are logged and can be read in the fixture's display (see "Readouts" on
page 19).

Lamp replacement

WARNING! Wear safety glasses and gloves when handling discharge lamps.
Replacement lamps are available from your Martin dealer.
The clear bulb must be perfectly clean. Do not touch it with your fingers. Clean the lamp with an alcohol
wipe and polish it with a clean, dry cloth before installing, particularly if you accidentally touch the bulb.
To replace the lamp:
1. Disconnect the fixture from power and allow it to cool for at least 30 minutes.
Average life Color temp.
3000 hours 8500 K
9000 hours 4200K
Table 2: Lamp specifications
Lamp
CRI Luminous flux
70 10 500 lm
95 14 000 lm
Efficacy
70 lm/w
88 lm/w
11