Martin MAC 2000 Wash User Manual page 17

2 To calibrate the zoom, select
adjusted up or down to move the diffuser lens relatively forward or back. Make any necessary adjustments
and press [Enter] to save the setting.
3 To calibrate the color wheels to an offset from their mechanically indexed position, select
→ →
          
the color wheel relatively forward or back from its indexed position. Make any necessary adjustments and
press [Enter] to save the setting. Repeat this procedure if necessary for color wheel 2 (
4 To calibrate the optional dimmer wheel to an offset from its mechanically indexed position, select
→ →
          
the dimmer wheel relatively forward or back from its indexed position. Make any necessary adjustments and
press [Enter] to save the setting.
5 Pan calibration is most useful when multiple fixtures are stacked vertically. To calibrate, set zoom, iris, and
tilt position for easy one-over-the-other comparison and set each fixture to the same pan DMX value. Select
one fixture to be the reference fixture. On the other fixtures, select
[Enter]. Adjust the offset as necessary to align the beam with the reference beam. Press [Enter] to save the
setting.
6 Tilt calibration is most useful when multiple fixtures are arranged horizontally. To calibrate, set zoom, iris,
and pan position for easy side-by-side comparison and set each fixture to the same tilt DMX value. Select
one fixture to be the reference fixture. On the other fixtures, select
[Enter]. Adjust the offset as necessary to align the beam with the reference beam. Press [Enter] to save the
setting.
7 To calibrate the dimmer, select
lens. Set the offset to 0 and then increase it until light is clearly projected onto the paper. Press [Enter] to
save the setting. Remove the paper.
8 To calibrate color mixing flags (cyan, magenta, yellow, and color temperature correction), project white
beams with no dimming and position them for easy comparison. On each fixture, including the reference,
→
     
select
be the reference. Adjust the offsets on the other fixtures to match the reference color. Press [Enter] to save
the setting. Repeat for
Software upload
The software update mode is normally engaged automatically by the upload device. If this does not occur,
see "Software installation" on page 29.
→ →
      
and press [Enter]. The default value of 128 can be adjusted up or down to move
and press [Enter]. The default value of 128 can be adjusted up or down to move
→ →
      
→
  
and press [Enter]. (This adds a defined amount of cyan.) Select one fixture to
       
(magenta),
Control panel
   
and press [Enter]. The default value of 128 can be
   
   
   
and press [Enter]. Hold a piece of paper over the
   
(yellow), and (CTC).
   
).
→ →
      
and press
→ →
      
and press
17