Sensor / Gas Selection; Sensor Selection; Gas Selection - Honeywell Sensepoint XCD Technical Manual

Sensepoint XCD Technical Manual

13.3 Sensor / Gas Selection

NOTE:
This Configuration option is not available for XCD units with EC sensors

13.3.1 Sensor Selection

"Select Sensor" sets the identity of the type of mV sensor attached to the XCD when XCD
does not detect the sensor type automatically. when sensor type is detected by XCD
automatically, the current sensor type can be confirmed in this menu.
The available mV sensors:
Ir-1
Ir-3
Cb-1
Selecting '' will move the operator to the Select Sensor screen. The first screen displays
the currently configured sensor. To select a new mV sensor, use '' to move through
the list, then use '' to make the selection or discard the selection and return to menu
mode by using abort function. If type of sensor is changed, calibration prompt will appear
to ask if you want to perform calibration. If the sensor type is not changed, it means that
XCD has detected the sensor type automatically and a user does not need to configure
the sensor type manually.

13.3.2 Gas Selection

Use "SEL gAS" to set the target gas for sensors capable of detecting multiple gases. The
available gases:
NDIR Infrared CO 0-2%Vol
2
NDIR Infrared Methane 0-100%LEL
Catalytic 0-100%LEL
Diagram 15: Sensor Selection
40
SPXCDHMANEN Issue 2